Pre-requisite for iGate 3G v20 and above
Posted by Account Administrator on 28 January 2016 04:55 PM
|
|
On site requirement:
Please connect the Gateway with a PC directly using left port and putting the PC in same IP segment, then connect to the Gateway using GateManager and configure the ip.cfg with final IP, format should be as below: ------------------------------------------------------------------ [System] DefaultGw=xxx.xxx.xxx.xxx [eth1] IpAddress=xxx.xxx.xxx.xxx/xx ------------------------------------------------------------- Make sure your changes are saved and then upload the file back to Gateway using "Upload to Gateway" option when you right click over any square in "Directory" section, then reboot the Gateway so changes take place using Commands menu, then "Restart Box/System" and choosing "Restart System". Once Gateway is back, you can connect it to the network using left port and access it remotely using the configured IP.
vGate requirement:
GateManager and Quickstart requirement:
| |
|