Knowledgebase
Pre-requisite for iGate 3G v20 and above
Posted by Account Administrator on 28 January 2016 04:55 PM

On site requirement:

  • Gateway is by default configured with following IPs:
  • 192.168.1.10 on the left port
  • 192.168.2.10 on the middle port
  • 192.168.3.10 on the right port

Please connect the Gateway with a PC directly using left port and putting the PC in same IP segment, then connect to the Gateway using GateManager and configure the ip.cfg with final IP, format should be as below: 

------------------------------------------------------------------

[System]

DefaultGw=xxx.xxx.xxx.xxx

[eth1]

IpAddress=xxx.xxx.xxx.xxx/xx

-------------------------------------------------------------

Make sure your changes are saved and then upload the file back to Gateway using "Upload to Gateway" option when you right click over any square in "Directory" section, then reboot the Gateway so changes take place using Commands menu, then "Restart Box/System" and choosing "Restart System". Once Gateway is back, you can connect it to the network using left port and access it remotely using the configured IP. 

 

vGate requirement:

  • vGate should be in v17.2.8 or upper.

GateManager and Quickstart requirement:

  • GateManager v21 is required in order to access and configure new 3G Gateway. 

 

(0 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments: